Close filters
from to
No results were found for the filter!
K+DCAN OBD Kabel mit USB, für MHD, Xhp, Motiv, Twisted Tuning, Wedge Performance, BimmerLabs K+DCAN OBD Kabel mit USB, für MHD, Xhp, Motiv, Twisted Tuning, Wedge Performance, BimmerLabs
Special cable for reading car BMW TP8 via NewTrasdata. It can be checked via OBD whether the existing control unit of the BMW TP8 series can be programmed. Before the boot mode, it can also be used to read out the password. ATTENTION:...
49.00€ *
- 5 spring contact pins / styli for BDM frame TurboPerformance, Anpin Kit
Anpin Kit, consisting of 5 spring contact pins. This kit can be used with the TurboPerformance BDM frame. Delivery: 4 spring contact pins with wire connection 1 spring contact pin for tapping with the alligator clip Important notice:...
99.00€ *
- Dimsport 4 styli for BNP position frame, K34DIMABNP
4 massive styli for use with the BNP position frame from Dimsport. The illustrations show equipment in use (not included). Important notice: This is an automatic translation. Please note that only the original german description is valid...
117.81€ *
- Bootpin with LED illumination
To commission the boot pin, an 8 mm opening must be pre-drilled in the housing of the control unit. The spring needle is attached to the end of the LED head. The LED connector is a DC jack. Important notice: This is an automatic...
49.00€ *
- Microcontact Clamp for TC1793 Infineon TriCore Processor, C34ACD012
Microcontact clamp for Infineon TriCore processor TC1793 Anpin Help for TC1793 Processor Family; in the pictures you can always see the same micro contact clip, but in different colors. If you press the lever on top, the small gripper...
Content 1 Stück
27.99€ *
- Acrylic boot pin holder with spring pin, Anpin help for the Bootpin set
The tip of the antistatic boot pin holder made of acrylic contains a spring-loaded test needle, on the underside are three high-performance magnets positioned. This Bootpinhalter has a firm hold on the retaining rail and is freely...
11.90€ *