No results were found for the filter!
E-GPT integrative wiring kit for Bosch EDC7 System. K34NTA22 required and not included in this Kit. Scope of delivery: K34NTA22-S7 K34NTA22-S8
53.55€ *
DENSO ECUs (KUBOTA / SUBARU / DAIHATSU) - board for connection (0.5 mm). Not included in New Trasdata Master / Slave Kits. Important notice: This is an automatic translation. Please note that only the original german description is valid...
224.91€ *
Bypass for FCA vehicles equipped with Secure GateWay. This bypass can be used to resolve communication issues during identification / read / write operations of NewGenius and MyGenius or other diagnostic tools on FCA vehicles equipped...
35.70€ * 39.90€ *
DENSO ECUs (KUBOTA / SUBARU / DAIHATSU) - board for connection (0.5 mm). Not included in New Trasdata Master / Slave Kits. Important notice: This is an automatic translation. Please note that only the original german description is valid...
71.40€ *
Flat cable for SSM connections (read) for PCR2.1 ECUs. Not included in New Trasdata Master / Slave Kits. Important notice: This is an automatic translation. Please note that only the original german description is valid for a legally...
23.80€ *
Double wiring for Ferrari/Fiat/Alfa/Lancia (gasoline) Connector cable for Bosch ME7XX hybrid Ecus (Kit of F32GN021 + F32GN022) Important notice: This is an automatic translation. Please note that only the original german description is...
189.21€ *
Special cable for programming Volvo cars via NewGenius For Volvo cars, OBD II with double CAN line Alternative to Alientech KESSV2 Cod. 144300K264 Important notice: This is an automatic translation. Please note that only the original...
117.81€ *
Dimsport programming cable Complete set for car including ABS plastic storage case These cables are included in the set: BMW: Diagnostic Connector (F32GN012) MERCEDES: Diagnostic Connector (F32GN014) MITSUBISHI: specific OBDII connector...
476.00€ *
The Digital Port Cable allows the connection of the two GPT signals directly to the plug of the ECU. It is equipped with two additional cables to connect ECUs with dual CAN buses. This is required for the following controllers: BMW...
23.80€ *
Special cable for reading car BMW TP8 via NewTrasdata. It can be checked via OBD whether the existing control unit of the BMW TP8 series can be programmed. Before the boot mode, it can also be used to read out the password. ATTENTION:...
35.70€ *